FAQ

You may not have - the numbers on your meter may have been transposed or hard to read. You could possibly have a leaky toilet or faucet that's difficult to detect. Just call the office and we'll work with you to solve the problem.

Check your meter and the surrounding area for possible leaks. Next, call our office and report low pressure for your area.

Color in water is usually caused by naturally occurring organic matter, minerals, or mineral build-up in the pipes. We flush our water system regularly to clean mineral build-up and other sediment from the pipes. If you receive discolored water, you should let your faucets run until the water is clear. Such substances typically do not pose a health hazard; however, we ask that you please report any instances of discolored water so that we may investigate.

Only chemicals that are approved by the National Safety Foundation for treatment of drinking water.

All public water systems are required to maintain a minimum chlorine level of 0.2 mg/L (tested at the end of each line) by state law. Systems that use chloramine as a disinfectant must maintain a level of 0.5 mg/L by state law. Our disinfectant levels are tested daily to ensure safety.

Most likely your water heater needs to be flushed. CAUTION: Most manufacturers recommend hiring a professional to flush your water heater. If you plan on doing this yourself, read the owner's manual to keep from being hurt and or damaging the water heater.

We may have received it after the due date or we may not have received it at all. Call our office and we will help you solve the problem.

A milky or cloudy appearance is usually caused by air bubbles in the water, which pose no health risk. If the water is allowed to sit, the air will dissipate and the water will clear. If the cloudiness does not disappear, please contact us so that we may investigate.

Spots are caused by hard water, or minerals that remain after the water has evaporated. Spots can be eliminated through use of a dishwasher rinse agent.

The hardness of water varies with the water’s source. The choice to buy a softener is an aesthetic one, since hard water is not harmful to health. However, water softeners typically increase the sodium content of the water, a factor that should be considered by people on low-sodium diets.

According to the United States Environmental Protection Agency, home treatment units are rarely necessary for health reasons. Most often, water treatment units are used to remove substances that affect the aesthetic qualities of the water. If you do choose to install a home treatment unit, it is important to follow the manufacturer’s maintenance instructions, because improperly maintained units can actually cause water quality problems.

Clean your coffee maker with vinegar and water as directed by the manufacturer.

The most common cause of odor in hot water is the water heater. If your cold water smells fine, check your water heater to ensure that the temperature setting is correct. Water heaters also need to be maintained (see manufacturer’s instructions). Please contact us if the odor persists or if it is present in both the hot and cold water.

Tap water providers and bottled water providers must meet the same water quality standards. In fact, tap water providers are required to conduct more frequent water quality testing and reporting than bottled water providers. Some consumers prefer the taste of bottled water, and some choose bottled water because they have special health needs. But tap water is a much better deal at costs of 1,000 times less than bottled water.

We conduct regular water system flushing to remove any mineral build-up and sediment from the pipes and also to ensure that water circulates adequately throughout the system. Fire hydrants may also be opened to conduct fire-flow capability tests.

Disinfectants are required because they prevent the spread of germs that cause diseases. Years ago, before disinfectants were used for drinking water, diseases such as cholera, typhoid fever, and dysentery were common. Drinking water disinfection has vastly improved the quality and safety of drinking water

We disinfect your water to ensure that it is free of harmful bacteria. To reduce any chlorine taste or smell, try refrigerating your water before drinking.

Dirt or sand can occur naturally in groundwater or as a result of a water line repair. We try to reduce the instances of dirt or sand in the water through regular flushing, which improves water quality by increasing the circulation of water in the pipes and removing most of the sediment from the water.

Water sources change at certain times of the year due to the availability of supplies. Surface water, or water that comes from sources like rivers and lakes, tends to taste slightly different than water pumped from underground aquifers.